A mould cools correctly only when every circuit carries exactly the right amount of water. Our column flow regulators set and display the f…

Sprues, trimmings and rejects don't have to end up in the bin. GETECHA has been building granulators and automation systems for plastics pr…

Conventional heater bands on an injection moulding barrel also heat the air around the machine. Inmex, a German manufacturer of plasticisin…

A worn screw or barrel doesn't show itself all at once – first the shot weight fluctuates, then reject rates climb and the cycle gets longe…

Wet granulate, unstable colourant dosing or manual hopper refilling cost both time and moulding quality. New Omap, an Italian manufacturer …

Uneven mould cooling only shows up on the moulded part – as warpage, sink marks or a longer cycle. The Manifold from SINGLE displays flow a…

A faulty heater or thermocouple in a hot runner is usually tracked down with a multimeter, pin by pin – on a 24-pole connector that means d…

Sprues of all kinds and small defective parts can be granulated right next to the injection moulding machine – economically, quietly and wi…